Spa Operator’s Guide
49
STEREO REMOTE CONTROL SYSTEM
To Program wireless remote:
• Turn Radio on (radio must be powered)
• Select the FM tuner source (this will activate the program switch).
• Press and hold the button inside the stereo enclosure.
• While holding the button inside the enclosure, press and release
any button on the remote.
(The red indicator light on the remote will
flash to indicate a button has been pressed.)
The button inside can now be released and the remote is programmed.
Buttons light up for 5 sec.when
sensor detects low light and button
is pressed
If the indicator light fails to come on
when a button is pressed
Replace batteries
Buttons light up for 5 sec.when
sensor detects low light and button
is pressed
If the indicator light fails to come on
when a button is pressed
Replace batteries
• Buttons light up for 5
sec. when sensor
detects low light and
button is pressed.
• If the indictaor light
fails to come on
when a button is
pressed replace
batteries.
• The remote range is
more that 75’
“REMOTE”
Programming Switch
“REMOTE”
Programming Switch
Buttons light up for 5 sec.when
sensor detects low light and button
is pressed
If the indicator light fails to come on
when a button is pressed
Replace batteries
upon reassembly: be sure
that the rubber keypad gets
“seated” back into the groove
to insure a watertight seal.
Comments to this Manuals