Wind River Spas Journey Instruction Manual download pdf (Page 47)

Spa Operator’s Guide

GENERAL XM OVERLAY

DIAGNOSTIC MESSAGE

A hardware error was detected in the in.xm pack

Reset the spa back by shutting the breaker off then on again, manually

change the status of all the pumps and accessories. If the problem

still persists, replace in.xm pack.

The InXm’s internal temperature is too high

Remove spa skirt and let system cool down. A system reset may be

required to clear error.

The Input voltage is too low

Was this error present since 1st power-up of the in.xm? If so, check

the input terminal connections to make sure they are correctly wired

and tight. Otherwise have a certiﬁed electrical verify the power line

quality.

Fuse #1 is blown

Replace the blown fuse with an identically rated fuse.

Fuse #2 is blown

Replace the blown fuse with an identically rated fuse.

Fuse #3 is blown

Replace the blown fuse with an identically rated fuse.

A hardware error was detected in the in.therm.

Restart the spa pack; make sure the heater restarts by changing the

set point. If problem still persists, replace in.therm

The error occurs if the in.therm is trying to heat water, but does

not detect any temperature rise.

Make sure the in.therm power cord is correctly inserted and sealed in

the in.xm. Restart the system. The system will preform a ﬂow check. If

the error code appears before any temperature as displayed, replace

in the in.therm.

Occurs when a “no ﬂo” condition is detected by the in.therm.

Make sure that the pump associated to the heater (pump #1 or

Circulation Pump is running. Check and clean ﬁlters. Make sure

water valves are open. Make sure there is no air lock condition ( or

any object obstructs passage of water within the in.therm).

This code occurs when a communications problem exists

between the in.xm and in.therm.

Make sure remoter heater cable is correctly connected,; then reset

system. If condition persists, visually verify male connector pins to

make sure they are not bent. If the above does not solve problem,

either in.xm or in.therm may need to be replaced.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53 54

No comments

Wind River Spas Journey Instruction Manual Page 47